Electrohome EAAC302 - Operating Instructions; Connecting Power; Battery Backup

- 12 -
CONNECTING POWER
The 1.8" Jumbo Alarm Clock Radio is equipped with an "AUTO TIME SET" feature. When
power is connected, the clock display will ash '2' which is TIME ZONE 2 (Eastern time) and
the default TIME ZONE setting. The correct time will be displayed, unless you are in another
time zone.
To select TIME ZONE 2 (Eastern time) as your default time zone:
• Press ONCE to conrm your selection.
To change your time zone upon setup:
• Press or until your own time zone appears on the display; press ONCE
to conrm your selection.
To change your time zone after setup:
• Press and hold the SNOOZE/SLEEP/DIMMER button until numbers ash.
• Press or until your own time zone appears on the display; press ONCE
to conrm your selection.
There are 8 programmed times zones:
BATTERY BACKUP
This alarm clock is equipped with a battery backup feature. This feature will restore your
alarm clock settings in the event of a power outage. The 3V, CR2032 Flat Lithium battery is
pre-installed at the factory, however, should you need to replace the battery, please read
the following instructions.
ATTENTION
• When replacing the battery, do not disconnect AC plug from AC outlet. Otherwise, current time and alarm will be reset.
• Do not plug or unplug the power cable if you have wet hands.
• If you are not planning to use the unit for an extended period of time, disconnect the power cable from the wall outlet.
• Do not pull on the cord! You may damage the power cord and may cause an electric shock when disconnecting the
power cord from the wall outlet. Pull rmly at the base of the plug.
OPERATING INSTRUCTIONS
Zone 0 - Newfoundland time
Zone 1 - Atlantic time
Zone 2 - Eastern time (default)
Zone 3 - Central time
Zone 4 - Mountain time
Zone 5 - Pacic time
Zone 6 - Alaska time
Zone 7 - Hawaiian time
OPERATING INSTRUCTIONS