Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Positioning
• The oven must be installed under an
extraction canopy that meets
AS 1668.2.
• To allow access to service panel and
protection of the control components,
the left hand side of the Combi oven
must have the following minimum
clearances:
Heat Source:
- 500mm clearance from another heat
source, in order to protect the oven
control components and allow access
to the service panel.
Non-Heat Source:
300mm clearance from a non-heat
source to allow access to the service
panel.
• Failure to adhere to these clearances
will potentially void the oven warranty
or add service costs due to lack of
access.
• Using a spirit level, ensure that the
Combi oven is level. Adjust the foot
height to level Combi oven.
• If using a stand, level the stand by
adjusting the feet, then level the Combi
oven.
To Next Page
Loading...
Need help?
General
