13
Possible actions during proving
Proving is started by setting
the oven temperature
between 0 - 49°C in Combi mode.
Press "Combi"
The LED lights
The last set oven temperature, time or core temperature flashes
for 5 seconds.
The LED marks the previous steam level in Combi mode*
Press "Time" and select proving time
Press "Oven temperature"
and choose temperature under 40°C
When the button's LED lights,
it isactivated for setting.
The last setting flashes on the display
for 5 seconds.
Set the new value using
the"Setting knob"
when thebutton's LED comes on.
Press "Start"
The LED lights
The displays show
- Actual oven temperature
- Remaining proving time
Cancel proving:
Press "Stop"
The LED goes out.
Proving
NOTE! The oven temperature cannot be set lower than 5°C above the set core temperature.
Setting new values Start Proving finished
When the proving time
is finished:
Buzzer sounds.
Time display flashes.
Press "Stop"
The buzzer stops.
The actual oven tempera
ture and time setting
are shown on the displays.
* Applies to Combi (Hot air/Steam), Reheating Gourmet and le Chef.
xx
xx
Check or change the oven temperature and time.
Press the actual button
For 5 seconds flash
set Oven temperature
and
remaining Time
If correction of "flashing" values will be done:
Set the new value using the "Setting knob"
when the button's LED is lit.
xx
xx
To Next Page
Loading...
