electrolux 31
1 When installing next to a wood-fuelled
boiler, a heatproof and heat-insulating
plate must be mounted at the height of
the appliance and at least 30 cm deep.
3 To secure it, you can bore 2 x 2.8 mm
holes at the top where the indents are
provided (detail C).
Electrical connection/power supply
The oven must be connected to the electric-
ity supply by a qualified electrician or a com-
petent person.
Use a H05VV-F type power cable or higher.
If there is no zero conductor in the house,
please order transformer R07, order number
940 304189 (2 parts).
The appliance must be installed with a sock-
et supply line, otherwise the fixed home elec-
trical system must include an isolating device
with at least a 3mm-contact separation to
enable a simultaneous and all-pole cut off
from the mains, according to NIN 2000.
For connecting to appliance directly to the
mains, use a minimum cable length of
120cm.
1. Opening the terminal box (detail D)
2. Open the catch on the cord grip (detail E).
3. See the connection diagram for the ter-
minal connection.
4. Secure the cord grip by pressing firmly
on the catch (detail F).
5. Closing the terminal box.
6. Fix the connection cable into the holes
provided to prevent it rubbing against
the drawer (detail G).
1 In case of repair the appliance must
be switched off from the mains.
Installation diagram 400V
Phase definitions:
L1, L2, L3 (or R, S,T)
To Next Page
Loading...
