• Connect the power cable as it is
INSTALLING
shown in the figure. This
machine is designed for a single
phase voltage of 230V The power
supply requires only outlets of 13
A fuse and a duble pole isolation
switc with at least 3 mm between
contacts.
THE MACHINE WITHOUT DRAWER
• Lay the U base plate of the
Insert the L plates, compensating
13A
machine on the shelf of the
cabinet.
•
for any space. The width of the
housing unit the coffee machine
depends on the thickness of the
cabinet’s sides. six side plates (four
being 2 mm thick and two 1 mm
thick) are provided to compensate
for the different possible measures.
They should be used to compensate
for the internal width of the
compartment, leading to a width of
560/570 mm.
34
To Next Page
Loading...
