Hardness of water:
• Before filling up the water reservo
make sure that the decalcifying Brita filt
has been soaked in cold water for at lea
30 min. Follow the instructions printed on
the filter package. After this operation
insert the filter into position inside th
water reservoir as it is shown in t
figure.
ir,
er
st
e
he
g
k
l
of
Brita filters are available from m
t, at
the
Remove the reservoir and fill it with
approximately 2.5 litres of water as shown.
• place the water reservoir in its
ousing tanking care to fully engage the
• If the machine will not be used for lon
periods, change the water in the tan
and drain the boiler: the machine wil
hold and dispense about half a litre
water (refer to the chapter”Hot water”).
• ost
supermarkets and domestic goods outles
our After-Sales Service Centres or at
Shops of Authorized Spare Parts.
•
re own
h
water valve on the base.
9
To Next Page
Loading...
