Check that the mounting brackets are level.
They can be adjusted if necessary by using the
extra holes at the ends of the brackets. Once the
brackets are level, drill a pilot hole through the
central hole in the bracket and fit the remaining
screw
HOW TO FINISH UNPACKING
Place packed appliance next to the space in
which it will be installed. See Fig. 8.
Remove the appliance packing except for
bottom tray which should be left in position until
the appliance is ready to be fitted into its
cabinet.
Ensure the owner is given these operating
instructions.
NOTE: It is imperative that the appliance is
left in the base to protect both the appliance
and the floor.
40
INSTALLATION INSTRUCTIONS
Important: Switch off at mains, miniature
circuit breaker and, if appropriate, remove fuse
before commencing any electrical work.
Fig.8
To Next Page
Loading...
