14
Clean the entire filter area
3 The strainer area does not have to be cleaned
after every drying cycle, but should be
checked regularly and cleaned of fluff if neces-
sary.
6. To do this, grip the top of the large mesh filter and
pull it forwards until it comes loose from the two
brackets.
7. Remove fluff from the entire filter area. It is best to
use a vacuum cleaner for this purpose.
8. Press both journals of the large mesh filter into the
brackets on the loading door until they snap into
place.
9. Re-insert fine strainer.
10.Press against the large mesh filter until it locks
into the interlock.
3 If the fine strainer is not fitted, the large mesh
filter will not snap into place and the loading
door cannot be closed.
Cleaning the door seal
Wipe the door seal with a damp cloth immediately
after the drying cycle has finished.
To Next Page
Loading...
