17
Cleaning the drum
1 Caution! Do not use abrasives or steel wool to
clean the drum.
3 Lime in the water or cleaning agents may form
a barely visible lining on the inside of the drum.
The degree to which the laundry has been
dried is then no longer detected reliably. The
laundry is damper than expected when re-
moved from the dryer.
Use a standard domestic cleaner (e.g. vinegar-based
cleaner) to wipe down the inside of the drum and
drum ribs.
Clean operating screen and
housing
1 Caution! Do not use furniture cleaners or ag-
gressive cleaning agents to clean the ma-
chine.
Use a damp cloth to wipe down the operating screen
and housing.
What to do if…?
Troubleshooting by your-
self
If, during operation, the dryer shows an error display
(one or more displays flashing on the programme
progress display), check first of all whether you can
remedy the problem yourself by means of the table
below. If you cannot solve the problem: Switch the
machine off and on again. Reset programme. Press
the START/PAUSE button.
If the error display is still shown, please contact our
after-sales service and inform them which displays
are flashing.
Problem Possible cause Remedy
Dryer does not work.
Mains plug is not plugged in or fuse
is not working correctly.
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Loading door is open. Close loading door.
Have you pressed the START/
PAUSE button?
Press the START/PAUSE button again.
Drying results unsatisfactory.
Wrong programme selected.
Select a different programme the next
time you dry
(see “Overview of programmes” sec-
tion).
Lint filter clogged. Clean lint filter.
Heat exchanger clogged with lint. Clean heat exchanger.
Incorrect volume of laundry.
Observe recommended loading vol-
umes.
Ventilation slots in base area cov-
ered up.
Uncover ventilation slots in base area.
Residue on inside surface of drum or
drum ribs.
Clean inside surface of drum and drum
ribs.
Conductance of water at installation
site differs from standard setting of
machine.
Re-programme standard setting for de-
gree of drying (see ‘Programming op-
tions’ section).
To Next Page
Loading...
