19
Programming options
Objective Implementation
Permanently program in the
audible signal which reminds
you that the programme is
complete.
1. Turn the programme selector to any programme.
2. Press the AUDIBLE SIGNAL (SIGNAL) button and hold down for approx.
5seconds.
A brief signal sounds several times. The AUDIBLE SIGNAL (SIGNAL) dis-
play flashes several times.
The setting is permanently programmed.
The setting is cancelled as described under 1 and 2.
Adjust detection of degree of
drying:
If the laundry is slightly drier or
slightly damper at the end of
the programme than with the
standard setting.
1. Turn the programme selector to any programme.
2. Press the AUDIBLE SIGNAL (SIGNAL) and SENSITIVE (SENSITIV) buttons
at the same time and hold down for approx. 5 seconds.
The current setting is displayed on the programme progress display:
– END (ENDE) display: Setting for drier laundry
– COOLING (ABKÜHLEN) display: Standard setting
– DRYING (TROCKNEN) display: Setting for damper laundry
3. Press the START/PAUSE button until the setting required appears on the
programme progress display.
4. Turn the programme selector to OFF (AUS).
The setting is permanently programmed.
If the EMPTY WATER (BEHÄL-
TER) display is to remain per-
manently deactivated when
using an external condensate
drain.
1. Turn the programme selector to any programme.
2. Press the DELAY TIMER (ZEITVORWAHL) and SPECIAL CARE (SCHON)
buttons at the same time and hold down for approx. 5 seconds. The EMP-
TY WATER (BEHÄLTER) display flashes briefly.
The EMPTY WATER (BEHÄLTER) display is permanently deactivated.
Settings may be cancelled as under 1 and 2, but the EMPTY WATER (BE-
HÄLTER) display is briefly illuminated (instead of flashing).
To Next Page
Loading...
