EasyManua.ls Logo

Electrolux EFC60001 - Recommendations and Suggestions; Installation Recommendations; Usage Safety Guidelines; Maintenance and Disposal Advice

Electrolux EFC60001
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 electrolux Recommendations and Suggestions
EN
Installation
The manufacturer will not be held li-
able for any damages resulting from
incorrect or improper installation.
The minimum safety distance be-
tween the cooker top and the extrac-
tor hood is 650 mm.
Check that the mains voltage corre-
sponds to that indicated on the rating
plate xed to the inside of the hood.
For Class I appliances, check that the
domestic power supply guarantees
adequate earthing.
Connect the extractor to the exhaust
ue through a pipe of minimum diam-
eter 120 mm. The route of the ue
must be as short as possible.
Do not connect the extractor hood to
exhaust ducts carrying combustion
fumes (boilers, replaces, etc.).
If the extractor is used in conjunction
with non-electrical appliances (e.g.
gas burning appliances), a sufcient
degree of aeration must be guaran-
teed in the room in order to prevent
the backow of exhaust gas. The
kitchen must have an opening com-
municating directly with the open air in
order to guarantee the entry of clean
air.
Use
The extractor hood has been de-
signed exclusively for domestic use to
eliminate kitchen smells.
Never use the hood for purposes
other than for which it has ben de-
signed.
Never leave high naked ames under
the hood when it is in operation.
Adjust the ame intensity to direct it
onto the bottom of the pan only, mak-
ing sure that it does not engulf the
sides.
Deep fat fryers must be continuously
monitored during use: overheated oil
can burst into ames.
Do not ambè under the range hood;
risk of re
The hood should not be used by chil-
dren or persons not instructed in its
correct use.
Maintenance
Switch off or unplug the appliance
from the mains supply before carrying
out any maintenance work.
Clean and/or replace the Filters after
the specied time period.
Clean the hood using a damp cloth
and a neutral liquid detergent.
The symbol on the product or on
its packaging indicates that this product
may not be treated as household waste.
Instead it should be taken to the appropriate
collection point for the recycling of electrical
and electronic equipment. By ensuring this
product is disposed of correctly, you will help
prevent potential negative consequences for
the environment and human health, which
could otherwise be caused by inappropriate
waste handling of this product. For more
detailed information about recycling of this
product, please contact your local council,
your household waste disposal service or
the shop where you purchased the product.
RECOMMENDATIONS AND SUGGESTIONS

Related product manuals