Electrolux EFC9140 - Page 37

ENGLISH 37
USE
The hood can be switched on pushing directly onto the requested speed without rstly
having to select 0/1 button
Button
Basic function
Indicator lights
Dual Function
L
Press briey to turn the lighting system on and off. Button off Lights off
Press and hold the button for 2 seconds to activate the lighting system in
“courtesy light” mode. The lights are lit at a reduced power of approximately
5W. This function can be disabled by pressing the button once again for 2
seconds or by pressing it briey to switch to normal lighting mode.
Button lit Lights on
Button lit Courtesy light on
T1
Turns the motor off from whatever speed it is set to.
Button lit Motor active
Motor inactive
Press and hold the button for 3 seconds with all the loads turned off (Motor
and Lights), to turn the Activated Charcoal Filter alarm on/off.
Button ashes twice F – Alarm On.
Button ashes once F – Alarm Off.
T2
Turns the motor on at speed one. Button on
T3
When pressed briey, turns the motor on at speed two. Button on Speed two on
Press and hold the button for approximately 2” to turn the Delay function
on and off, that is to say to turn the appliance off after a 20 minute delay.
Suitable to complete elimination of residual odours. Can be activated
from the OFF position and from speeds 1, 2, 3. Cannot be activated with
Intensive speed On.
Buttons ashing
(T1+T2 or T3
or T4)
Delay functionActive
T4
Turns the motor on at speed three. Button on
T5
Turns the motor On and Off at Intensive speed for a timed period of 5
minutes. At the end of the 5 minutes the appliance will automatically return
to the speed that was set before. If the appliance was turned off at the time
of activation, at the end of the 5 minutes the system will return to speed one.
Button on
F
Press and hold for 4 seconds to reset the lter alarm indicator, shown by
ashing of button T1. This procedure can only be carried out with the motor
off.
Button on
Signals the Metal Grease Filter
saturation alarm, indicating that it
is necessary to wash the lters.
The alarm is triggered after the
Hood has been in operation for
100 working hours.
Button ashing
When this is activated, it signals
the Activated Charcoal Filter
saturation alarm, indicating
that the lter must be changed;
the Metal Grease Filters must
also be washed. The Activated
Charcoal Filter saturation alarm
comes into operation after the
Hood has been working for 200
hours.
      