4
Gas from the tank (1) is released from the low pressure regulator (2) into the hose or tube (3), travelling pass
the elbow coupling to the valve (4). To ignite the burner, press down and turn the safety valve (5) counter-
clockwise simultaneously. This opens up the valve, letting the gas to the nozzle of the burner (6), and turns the
ignition switch to on (7) at the same time. The electrical current is automatically supplied from the battery to
spark plug generator (8), and then to the pin heads (9), causing the ignition (10). The burner is ignited and bursts
into flame (11).
3. COMPONENTS SPECIFICATION
- Glass 2B : Float glass 8.0x500x760 mm
- Bottom plate forming : EG
- Knob : Phenolic PH31 heat + flame resistance
- Washer : fiber
- Hose end : Brass (size1/2)
- Rubber grommet (glass model) : Silicone heat resistance
- Spark generator 4p : 1.5Vdc+90C+electrode10KV
To Next Page
Loading...
