What to do if my Electrolux EHG7332X Hob isn't sparking?
If you're not getting a spark when you activate the control knob on your Electrolux Hob, it could be due to a few reasons: * The battery might be flat. Try replacing the battery. * The battery polarity might be incorrect. Re-orient the battery to the correct position. * The ignition electrode could be wet or dirty. Dry or clean the ignition electrode.
How to fix Electrolux EHG7332X Hob burner that won't light?
If the burner on your Electrolux Hob won't light even when the spark plug is working, there are several potential causes: * The gas supply valve might be turned off. In this case, turn on the gas supply to the appliance. * The control knob might not be on. Turn the knob on. * You might be turning the wrong knob. Ensure the knob corresponds to the burner you want to light. * There could be a port blockage in the ignition area. Make sure that ports in the ignition area are clean and dry. * The ignition electrode might be wet or dirty. Dry or clean the ignition electrode. * The burner crown might be incorrectly fitted, causing sparking at the wrong point. Ensure the crown is seated properly so that the spark fires to the receiving point in the burner crown.
Why are the flames uneven on my Electrolux EHG7332X Hob?
Uneven or lifting flames on your Electrolux Hob can be caused by: * Blocked or wet flame ports. Clean or dry the flame ports. * An incorrectly fitted burner cap/crown. Ensure these components are fitted correctly.
Why is my Electrolux Hob cooking so slowly?
Low heat and slow cooking on your Electrolux Hob can be caused by using incorrect cooking utensils. Make sure you are using pots and pans with bases that fit the size of the burner.
Lists specific accessories for city gas conversion and installation.
Step-by-step guide for cleaning the burner nozzle.
Instructions for safely removing the hob to access internal parts.
Lists specific accessories for city gas conversion and installation.
Step-by-step guide for cleaning the burner nozzle.
Instructions for safely removing the hob to access internal parts.
General| Type | Gas Hob |
|---|---|
| Number of Burners | 3 |
| Material | Stainless Steel |
| Control Type | Knob |
| Flame Failure Safety Device | Yes |
| Ignition Type | Automatic |
| Burner Types | Semi-Rapid, Auxiliary |
| Gas Type | LPG |
To Next Page