Installation Requirements
NOTE
Hoses are not included with washer purchase.
See “Accessories” section for various inlet hose kits to fit your
specific installation.
Shipping Hardware
Foam shipping support (under wash tub)
removed and stored
Shipping bolts and spacers removed
from rear of appliance and stored
Hole plugs (shipped in bag in drum)
installed in holes in backsheet
Leveling
Washer is level, side-to-side and front-
to-back
Cabinet is sitting solid on all corners
Water Supply
Use only new hoses and verify rubber
sealing washers are installed
HOT supply is connected to HOT inlet
and COLD supply is connected to
COLD inlet
HOT and COLD water supply
turned on
No leaks present at water supply
connections or appliance inlet
connections - recheck in 24 hours
Drain
Stand pipe or wall drain height min. 24”
Drain hose snapped in “U” channel
(shipped in drum)
Drain hose secured in place with
cable tie (shipped in drum)
Electrical Power
House power turned on
Washer plugged in
Final Checks
Installation Instructions and Use
& Care Guide read thoroughly
Door locks and water enters drum when
cycle starts
Registration card sent in
Installation Checklist
Tools and materials needed for installation:
Adjustable
pliers
Adjustable
wrench
3/8" or
10 mm
OR
OR OR AND AND
Ratchet and
socket set
Carpenter’s level
Optional
universal
wrench
Please Read and Save this
Guide
Thank you for choosing Electrolux, the pre-
mium brand in home appliances. These Instal-
lation Instructions are part of our commitment
to customer satisfaction and product quality
throughout the life of your new appliance.
Questions?
Toll-free telephone and online support:
U.S. :1-877-4ELECTROLUX
(1-877-435-3287)
www.electroluxappliances.com
Canada: 1-800-265-8352
www.electroluxappliances.ca
4
To Next Page
Loading...
