Electrolux ENN26800 - What to Do If...; Water Flows on the Rear Plate; Into the Refrigerator; on the Ground; The Temperature in the Appliance is Too Low;High; The Temperature in the Refrigerator;Freezer is Too High

Problem Possible cause Solution
The door has been opened too
frequently.
Do not keep the door open longer
than necessary.
The product temperature is too
high.
Let the product temperature de-
crease to room temperature be-
fore storage.
The room temperature is too
high.
Decrease the room temperature.
Water flows on the rear
plate of the refrigerator.
During the automatic defrosting
process, frost defrosts on the
rear plate.
This is correct.
Water flows into the re-
frigerator.
The water outlet is clogged. Clean the water outlet.
Products prevent that water
flows into the water collector.
Make sure that products do not
touch the rear plate.
Water flows on the
ground.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
Attach the melting water outlet to
the evaporative tray.
The temperature in the
appliance is too low.
The temperature regulator is not
set correctly.
Set a higher temperature.
The temperature in the
appliance is too high.
The temperature regulator is not
set correctly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Let the product temperature de-
crease to room temperature be-
fore storage.
Many products are stored at the
same time.
Store less products at the same
time.
The temperature in the
refrigerator is too high.
There is no cold air circulation in
the appliance.
Make sure that there is cold air
circulation in the appliance.
The temperature in the
freezer is too high.
Products are too near to each
other.
Store products so that there is
cold air circulation.
There is too much frost. Food is not wrapped correctly. Wrap the food correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is not
set correctly.
Set a higher temperature.
REPLACING THE LAMP
Caution! Disconnect the plug from the
mains socket.
1. Press on the rear hook and at the same
time slide the cover in the direction of
the arrow.
2. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the light bulb cov-
er).
3. Install the lamp cover by fixing it into its
original position.
4. Connect the plug to the mains socket.
10 electrolux