20
CARE AND CLEANING
Before cleaning always allow the cooling fan to
cool the appliance down before switching off at
the electric ity supply.
CLEANING MATERIALS
Before using any cleaning materials on your appliance,
check that they are suitable and that their use is
recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Harsh abrasives
and scourers should also be avoided as damage will
occur.
CLEANING THE OUTSIDE OF THE
APPLIANCE
Do not
use abrasive cleaning materials e.g. Hob Brite,
Brillo pads or scourers on painted or printed finishes as
damage may occur.
Regularly wipe over the control panel, doors and
handles using a soft cloth and hot soapy water. To
prevent streaking finish with a soft cloth.
Stainless Steel cream cleaners are abrasive and should
be avoided as they may dull the surface finish.
Any
spillage on the st ainl ess steel finish must be wiped o ff
immediately.
Do not attempt to remove any of the control
knobs from the appliance as this may cause
damage an d is a safety hazard.
Under no circumstances should the door
assembly be detached from the product for
clean ing.
REMOVI N G AND REPL ACI NG W IREW ORK
RUNNERS
Remove all shelves and furniture from the oven.
Hold the wirework at the bottom, unclip from the cavity
side and gently pull towards the centre of the oven.
Unhook the runner at the top and remove from the
cavity.
To replace the runners, hook the wirework side runner
into the cavity, slide back and press into place.
Ensure the wirework runners are firmly in
position before repl ac ing the oven shel ves.
To Next Page
Loading...
