31
HOW TO F I N ISH UN PA CK I NG
•
Place packed appliance next to the space in which
it will be installed.
•
Remove the appliance packing except for bottom
tray, which should be left in position until the
appliance is ready to be fitted into its cabinet.
NOTE: It is imperative that the appliance is left in
the base to protect both the appliance and the
floor.
•
Ensure the user is given these operating
instructions.
Important: Switch off at the mains, miniature
circuit breaker and if appropriate, remove fuse
before commencing any electrical work.
TO REMOVE CO V ER OF M AI N S TERM INA L
From the rear of the appliance, remove mains input
terminal cover to gain access to terminal block.
•
First remove retaining screw with pozidrive
screwdriver. See Fig. 4.
•
Prise cover loose using screwdriver in position (1)
then lever off with screwdriver in position (2) at
either side. See Fig. 5.
•
Lift cover and remove screw from cable clamp.
See Fig. 6.
Fig. 4
To Next Page
Loading...
