Electrolux ERF501L - AC Output Test Procedures; Digital Output Test Procedures

Q&CI - Technical Support
SERVICE MODE LED COMBINATIONS
Service mode feedback consists of light combinations.
Table note: FR: Refrigerator, FZ: Freezer, EV: Evaporator
AC output test
Tests AC loads connected to the appliance, only physically mounted components are displayed. When
service mode starts, all components are switched off.
AC Load
1
2
3
4
5
FR compressor
on
FZ compressor
blinking
Heater
on
FR lamp
on
on
AC EV fan
on
blinking
AC FR fan
blinking
EV electro valve
blinking
on
AC Zero degree fan
blinking
blinking
Water faucet
on
FZ lamp
on
on
Auger motor
on
blinking
Ice selector
on
on
AC condenser fan
on
on
on
Perfect drawer
on
on
blinking
Balance heater
on
blinking
Frame heater
on
blinking
on
FR VCC compressor
on
on
blinking
blinking
FZ VCC compressor
on
blinking
Condenser electro valve
on
blinking
blinking
Digital output test
All digital outputs connected to electronics are automatically switched off at the start of the test.
Digital output
1
2
3
4
5
FR lamp
on
blinking
on
Zero degree lamp
on
blinking
blinking
DC EV fan
on
blinking
on
DC FR fan
on
blinking
on
on
DC Zero-degree fan
on
blinking
on
blinking
DC Condenser fan
on
blinking
blinking
FZ lamp
on
blinking
blinking
blinking
DC Air filter fan
on
7