5.1 Consumption values
Programme
1)
2)
Water
(l)
Energy
(kWh)
Duration
(min)
10.5 0.835 235
9.6 - 13.1 0.74 - 1.06 120 - 170
13.9 - 16.9 1.14 - 1.40 204
10.8 - 13.2 0.97 - 1.11 160
9.3 - 11.4 0.54 - 0.66 30
8.9 - 10.9 0.58 - 0.70 60
1)
The pressure and the temperature of the water, the variations of the mains supply, the
options, the quantity of dishes and the degree of soil can change the values.
2)
The values for programmes other than ECO are indicative only.
5.2 Information for test
institutes
To receive the necessary information for
conducting performance tests (e.g.
according to: EN60436 ), send an email
to:
info.test@dishwasher-production.com
In your request, include the product
number code (PNC) from the rating plate.
For any other questions regarding your
dishwasher, refer to the service book
provided with your appliance.
6. SETTINGS
6.1 Programme selection mode
and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter user mode.
Settings available in the user mode:
• The level of water softener according
to the water hardness.
• Activation or deactivation of the rinse
aid empty notification.
• The level of rinse aid according to the
required dosage.
• Activation or deactivation of the
AirDry.
As the appliance stores the saved
settings, there is no need to configure
it before every cycle.
How to set the programme
selection mode
The appliance is in programme selection
mode when the programme indicator
is on and the display shows the
programme duration.
After activation, the appliance is in
programme selection mode by default. If
not, set the programme selection mode
the following way:
Press and hold simultaneously Delay
and Options until the appliance is in
programme selection mode.
How to enter user mode
Make sure the appliance is in
programme selection mode.
ENGLISH 9
To Next Page
Loading...
Need help?
General
