2
30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with an Electric Oven and a Gas Cooktop)
1 1/8"
(2,86 cm)
FRONT OF
CABINET
F
Ref.
22 7/8"(58,1 cm) min.
23 1/4"(59,05 cm) max.
(see Note 4)
NOTE:
1.Do not pinch the power supply cord or
the flexible gas conduit between the
range and the wall.
2.Do not seal the range to the side cabinets.
3.24" (61 cm) minimum clearance between
the cooktop and the bottom of the
cabinet when the bottom of wood or
metal cabinet is protected by not less than
¼" (0,64 cm) flame retardant millboard
covered with not less than No. 28 MSG
sheet metal, 0,015"(0,4 mm) stainless
steel, 0,024"(0,6 mm) aluminum, or
0,020" (0,5 mm) copper.
30" (76,2 cm) minimum clearance when
the cabinet is unprotected.
4.For cutouts below 22 7/8"(58,1 cm),
appliance will slightly show out of the
cabinet.
5.Allow at least 19 ¼" (48,9 cm) clearance
for door depth when it is open.
IMPORTANT: Cabinet and countertop
width should match the cutout width.
E
E
35 5/8" (90,5 cm) -
36 5/8" (93 cm)
30" (76,2 cm)
28 5/16" (71,9 cm) 30±1/16"
(76,2±0,15 cm)
21 3/4" (55,2 cm) Min.
22 1/8" (56,2 cm) Max
24" (61 cm) Min. with
backguard
36 5/8" (93 cm) Max.
35 3/4" (90,8 cm) Min.
A. HEIGHT B. WIDTH D. DEPTH TO
FRONT OF RANGE
E. CUTOUT WIDTH ***
(Countertop and
Cabinet)
F. CUTOUT
DEPTH
G. HEIGHT
OF COUNTERTOP
31½" (80 cm)
C. COOKTOP
WIDTH
*** IMPORTANT: To avoid cooktop breakage for cutout width (E dimension) of more than
30 1/16" (76,4 cm), make sure the appliance is centered in the counter opening while
pushing into it. Raise leveling legs and the rear adjustable wheels at a higher position
than the cabinet height (see page 3), insert the appliance in the counter and then level.
Make sure the unit is supported by the leveling legs at the front and the
wheels at the back and NOT by the cooktop itself.
Door Open
Side Panel
To Next Page
Loading...
