olutions to Common Pro (eros 53
Beforecalling for service, review this list. it may save you bothtime and expense. This list
includes common experiences that are not the result of defec_ve workmanship or material
in your cooktop.
OVENCONTROLBEEPSAND D)SPLAYSAN "F" ERRORCODE
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
• Electronic control has detected a fault condition. Push CANCEL pad to clear the
display and stop the display from beeping Reprogram the oven. If a fault reoccurs,
record the fault number, push the CANCEL pad and contact an authorized servicer.
(NSTALLAT(ON
[] [] [] U [] [] [] I [] I [] [] [] [] [] [] [] [] [] [] [] []
• Place oven rack in center of oven. Place a level on the oven rack. Contact installing
agent if rack and cabinet cutout flooring are not level.
• Kitchen cabinet misalignment may make range appear to be not level. Be sure cabinets
are square and (evet. Contact cabinet maker to correct problem.
ENT(RE_NGE DOESNOTOPERATE
[] [] il! [] [] [] [] [] [] [] [] [] [] II [] [] [] [] [] [] []
• When the range is first plugged in, or when the power supply to the oven has been
interrupted, the display will flash. The range cannot be programmed until the clock is
set.
. Be sure electrical cord is securely connected into the electrical junction box.
° Cord/plug is not installed and/or connected. Cord is not supp(ied with range. Contact
your dealer, installing agent or authorized servicer.
- Service wiring not complete. Contact your dealer, installing agent or authorized
servicer.
• Power outage. Check house lights to be sure. Call your local electric company.
• Short in cord/plug Replace cord/plug
• Controls are not set properly. See instructions to set the controls.
• House fuse has blown or circuit breaker has tripped immediately following installation.
• House fuse may not be fully engaged. Check fuse and screw or engage circuit breaker
securely.
OVEN L)GNTDOESNOTWORK
[] [] III B [] [] [] [] [] [] [] [] [] !1 [] [] [] II [] []
* Burned-out or loose bulb. Follow the instructions under Oven Light to replace or
tighten the bulb.
[] []
To Next Page