22 ENGLISH
9.6 Changing A Programme
Changing a running programme is
possible only by resetting it.
• Turn the programme selector
knob to "Off" position to cancel
the programme and to turn off the
appliance.
• Turn the programme selector knob
to the new programme position and
change any available options. Press
"Start/Pause (
)" to start the new
programme.
9.7 Changing The Options
9.8 Opening The Door
It may be possible to change some of
the options after a wash programme has
started.
1. Press the touchpad Start/Pause. The
indicator will start flashing.
2. If available change the options that
you wish.
3. Press Start/Pause again. The
programme will continue.
While a programme or the Finish In is
operating, the appliance door is locked
and the display shows the indicator "
".
First, set the machine to PAUSE by
pressing the "Start/Pause" touchpad. Wait
until the door lock indicator goes off,
then the door can be opened.
If the door lock indicator "
" does not
disappear, this means that the machine
is already heating and the water level is
above the bottom edge of the door or
the drum is turning. In this case the door
CAN NOT be opened. If you need to
open it, you must drain the water to open
the door.
The appliance will not drain the
water. (except programmes; Spin, Rinse
+ Spin, Tub Clean)
WARNING!
In case of emergency please refer to
section "Emergency door opening" on
page 33.
9.9 At The End Of The Programme
• The appliance stops automatically.
• The acoustic signal will operate.
• The display will show "
".
• The indicator of the touchpad Start/
Pause goes off.
• The door lock indicator "
" goes off.
• Remove the laundry from the
appliance. Make sure that the drum is
empty.
• Keep the door partly open, to prevent
mildew and odours.
• Turn off the water tap.
9.10 When The Washing Programme
Is Completed, But There Is
Water In The Drum
(Option "Rinse Hold " is used.)
• The drum turns regularly to prevent the
creases in the laundry.
• The indicator "Start/Pause" flashes to
remind you to drain the water.
• The door lock indicator "
" is on. The
door stays locked.
To drain the water:
1. Press the "Start/Pause
" touchpad.
The appliance drains the water and
spins with the maximum spin speed for
selected programme.
You must drain the water to open
the door.
At the end of the programme, the
time remaining can suddenly decrease
from 7 minutes or less to 0 due to the
overestimated total programme time
during the load sensing phase. In some
cases (with perfectly balanced load)
the programme time can be shorter
than the time estimated after the load
sensing phase is completed. This is a
normal behaviour of the machine and
not a cause for concern as it does not
compromise its performance.
To Next Page
Loading...
