Electrolux EWF1024D3WC - Child Lock Option; Add Clothes

18 ENGLISH
7.2 Settings
This setting permits you to either enable
or disable the buzzer at the end of the
programme. As an example, you might
wish to disable this buzzer when you
start a wash when going to bed, so that
when the wash finished approximately 1
hour later, it will not disturb you through
the night.
Enabling/Disabling End-Of-Wash
Buzzer
• To disable the buzzer sound, press
"Temp" and "Spin" touchpads at the
same time until the icon "
" will
show on display along with buzzer
sound.
Error warning beeps such as critical
faults are not disabled.
Child Lock ( ) Option
Your appliance is provided with CHILD
SAFETY LOCK which permits you to leave
the appliance unsupervised with the
door closed without having to worry that
children might be injured by or cause
damage to the appliance.
• To activate the function, press and
hold "Hygienic Care" touchpad about
3 seconds until the display shows the
icon "
".
• To deactivate the function, press and
hold this touchpad at the same time
until the display shows the icon "
".
To set "Child Lock" option:
Set this option after pressing the
Start/Pause touchpad.
If you press any touchpad while
Child Lock is activated, the icon
"
" will flash on display 3 times
along with buzzer sound.
This function remains enabled even
after the appliance is switched off.
7.3 Start/Pause ( ) and Add
Clothes ( ) Touchpad
This touchpad has 2 functions:
After you have selected the desired
programme and options, press this
touchpad to start the machine. The
Start/Pause pilot light will stop flashing
and remain lit.
If you have selected a "Finish In"
option, the countdown will begin and
will be shown on the display.
To interrupt a programme which is
running, press this touchpad to pause
the machine, the Start/Pause pilot light
flashes.
To restart the programme from the
point at which it was interrupted, press
this touchpad again, the Start/Pause
pilot light will stop flashing.
1. Start/Pause ( )
1. Pressing the "Start/Pause" touchpad
to pause the programme.
2. Wait for the machine to come to a
complete stop before opening the
door (wait for door lock "
" icon
to turn off).
3. Add clothing and close the door.
4. Resume the programme by pressing
"Start/Pause" touchpad again.
2. Add Clothes ( )
You can only add clothes when the
icon "
" shown on the display.
• To return to default configuration press
these 2 touchpads at the same until
the icon "
" will show on display
along with buzzer sound.