Electrolux EWF14742 - Final Loading and Detergent Steps; Closing Door and Final Checks; Detergent Dispenser Drawer

14 www.electrolux.com
Measure out the amount of
detergent required, pour it into the
main wash compartment ( ).
Pull out the dispenser drawer until
it stops.
-
-
Measure out the detergent and the
fabric softener;
2.
If you wish to carry out the
“Prewash” phase, pour it into the
compartment marked .
If required, pour fabric softener
into the compartment marked
(the amount used must not
exceed the “MAX” mark in the
drawer).
-
-
Close the drawer gently.
-
ATTENTION!
If you turn the program selector dial
to another program when the
machine is working, the red
Start/Pause pilot light will flash 3
times and the message ‘ ’ will
appear on the display to indicate a
wrong selection. The machine will
not perform the new selected
program.
The appliance will automatically
adjust the selected program duration
according to the type and size of the
load.
-
The display will show adjusted
program duration.
-
Step 4 - Starting A Program
To start a
program, press
the Start/Pause
( ) touchpad,
the corresponding pilot light will stop
flashing and a default program duration
will be displayed on the screen.
After approx. 15 minutes from the
start of a program:
Do not use gelatinous or thick
liquid detergents.
-
Do not put more liquid than the
maximum level.
-
Do not set the DELAY START.
-
Do not set the PREWASH phase.
-
When you use the liquid
detergent: