ENGLISH 21
8.7 Cleaning The Pump
The appliance does not drain the
water.
The drum cannot turn.
The appliance makes an unusual
noise because of the blockage of
the drain pump.
The display shows an alarm code
because of the problem with
water drain.
Regularly examine the drain pump
and make sure that it is clean.
Clean the pump if:
1. Disconnect the mains plug from
the mains socket.
2. Do not remove the filter while
the appliance operates. Do
not clean the drain pump if the
water in the appliance is hot.
The water must be cold before
you clean the drain pump.
WARNING!
To clean the drain pump:
1. Open the drain pump door.
2. Pull the flap down.
3. Put a container below the recess
of the drain pump to collect the
water that flows out.
Having removed the drawer, use a
small brush to clean the recess,
ensuring that all washing powder
residue is removed from the upper
and lower part of the recess.
Replace the drawer and run the
rinse program without any clothes
in the drum.
8.6 Cleaning The Drawer Recess
To Next Page
Loading...
