30 troubleshooting electrolux water aid washing machine
Problem Possible causes (digital display code) What to do
Clothes still dirty after
wash program.
Not enough or no detergent. Check detergent use and rewash clothes.
Too many clothes in load. Remove some clothes and rewash.
Incorrect selections for Program, Dirt
Level or water Temp.
Reselect settings.
Incorrect water level selected. Use auto sensing water level and rewash clothes.
Clothes still wet or
sudsy after wash
program
Poor rinsing and spin due to excessive
suds
In future use less detergent & ONLY use a low sudsing,
front load washer detergent in this machine, such as Cold
Power for Front Loaders and High Efficiency Top Loaders or
detergent labelled “Matic”.
Scraping noise on spin.
Bra wire or other thin item caught
between inner and outer washbowls.
If item is visible, remove with pliers.
Use wash bag in future.
Humming, clicking
and other intermittent
noises.
Bowl rotation at start of wash. Normal noise.
Lid will not open
Machine is at a spin stage and
‘Lid Locked’ light is ON
If you want to access the bowl, wait until stage is complete
and light is OFF. Then you can open the lid.
At end of wash. Machine is nishing nal
spin & the lid lock release stage.
Wait a short while until ‘Lid Locked’ light is OFF
Lid may be stuck in the locked position. If ‘Lid Locked’ light is OFF, press Power to turn off machine,
then press Power again. If lid still will not open you should
call Service.
Troubleshooting
Model: EWT806
To Next Page
Loading...
