Fault information and a guide for when you should call for service
If you have a problem with your washing machine and before you call service, make sure you have followed ALL of the
instructions that may remedy the problem. You will nd instructions in the ‘Troubleshooting’ section on pages 29 and 30
and in the table below.
When the washing machine detects a problem that requires your attention, you will be alerted. The machine will warn you
of this problem by displaying a fault code in the digital display, accompanied by ‘Beeping’.
Fault information and the action you should take are described in the following table.
Digital display
fault display
Problem Action to take
Not filling with water Make sure both wall taps are on, and hose filters not blocked.
Raise drain hose if water owing out of drain hose.
Press Start/Pause to re-start wash.
If problem remains, call Service.
Water is not turning off. If water is pouring onto the floor, turn both wall taps OFF. Wait a few minutes to see if
fault is corrected - if not, call Service.
Water not draining
correctly.
The drain pump will switch off and on repeatedly to clear any blockage.
Wait a few minutes to see if the fault is corrected.
If not, press Start/Pause then check the drain hose for blockage. Press Start/Pause to
continue wash.
If problem remains, call Service.
Water level sensor not
operating correctly.
The machine will only permit draining. If not draining, press Advance to select spin stage,
then press Start/Pause to start pump.
If this problem is repeatedly experienced, call Service.
Control panel not
functioning properly.
Press Power button to turn machine off. Restart the machine.
If problem still exists, call Service.
Motor fault Wait, the problem may self clear.
If not, select Spin to drain water from bowl.
You may have to press Start/Pause to commence draining.
If this problem is repeatedly experienced, call Service.
Model: EWT806
32 troubleshooting fault displays electrolux water aid washing machine
Troubleshooting fault displays