What to do if my Electrolux EWW12842 does not start?
If your Electrolux Washer/Dryer isn't starting, make sure the door is firmly closed. Check that the plug is properly inserted into the power socket and that there is power at the socket. Also, ensure you've pressed the Start/Pause button and that the delay start function is not active. If delay start is selected, cancel it to start the wash immediately.
How to improve unsatisfactory washing results from Electrolux EWW12842?
If you are not satisfied with the washing results from your Electrolux Washer/Dryer, increase the amount of detergent or use a different one. Treat stubborn stains with commercial products before washing. Ensure you have selected the correct temperature and reduce the laundry load if it's excessive.
How to fix Electrolux Washer/Dryer that does not start?
If your Electrolux Washer/Dryer isn't starting, make sure the door is firmly closed, the plug is properly inserted into the power socket, and the Start/Pause button has been pressed. Also, check your domestic electrical installation to ensure there is power at the socket. If a delayed start is set, cancel it to begin the wash cycle immediately.
Why does spinning start late or not at all in my Electrolux EWW12842 Washer/Dryer?
If spinning starts late or not at all in your Electrolux Washer/Dryer, the electronic unbalance detection device may have activated because the laundry isn't evenly distributed in the drum. Pause the machine and redistribute the laundry manually.
What to do if the door of my Electrolux EWW12842 will not open?
If the door of your Electrolux Washer/Dryer won't open, it could be because the program is still running; wait until the end of the washing cycle. The door lock may not have released yet, so wait about 5 minutes. If there's water in the drum, select the ‘Spin’ program to empty it out.
How to reduce vibration and noise in my Electrolux EWW12842 Washer/Dryer?
Excessive vibration and noise in your Electrolux Washer/Dryer can be caused by a few things. Ensure the transit bolts and packing have been removed and that the support feet are properly adjusted to level the appliance. An uneven distribution of laundry in the drum can also cause this issue; pause the machine and redistribute the load manually. If there's very little laundry, adding more could help. Also, detergent overdose can cause noise and vibrations, so reduce the detergent quantity or use another one.
What to do if the Electrolux Washer/Dryer door will not open?
If your Electrolux Washer/Dryer door won't open, wait until the washing cycle is complete or about 5 minutes for the door lock to release. If there is water in the drum, select the ‘Spin’ program to drain it. If the issue persists, it could indicate a failure, and you should read carefully “Emergency door opening”.
Why is my Electrolux Washer/Dryer vibrating or noisy?
If your Electrolux Washer/Dryer is vibrating or noisy, ensure that the transit bolts and packing have been removed and that the support feet are properly adjusted. Make sure the laundry is evenly distributed in the drum; if not, pause the machine and redistribute it manually. Also, ensure you are not using too much detergent. If the floors are unstable, refer to the relevant paragraph in the 'Positioning' section.
Why is there water on the floor near my Electrolux EWW12842?
If you find water on the floor near your Electrolux Washer/Dryer, it could be due to several reasons. You might be using too much detergent or an unsuitable type that creates excessive foam. Check the water inlet hose connection for leaks. Also, inspect the drain hose for any damage; if damaged, replace it.
General| Brand | Electrolux |
|---|---|
| Model | EWW12842 |
| Category | Washer/Dryer |
| Language | English |
To Next Page