Electrolux FFLE3911QW

To Next Page

Tech Sheet – Laundry Center FFL(E/G)3911/4033 GD000006035-B

Page 1 of 11

DIAGNOSTIC SYSTEM – FFL(E/G)3911QW and FFL(E/G)4033QW (Washer)

This information is intended for Qualified Technicians Only.

CAUTION: DISCONNECT ELECTRICAL POWER BEFORE SERVICING

1 Diagnostic Mode

This mode is used in several conditions:

• In factory assembly line to perform a manual test of the machine functionality (final

assembly test).

• By service to check for faults and repair the machine.

• In the labs to check the machine functions.

2 Entering Diagnostic Mode

1. Set the cycle selector to pre-soak on both models (near 9 o’clock position) and the temperature

knob at the far left CCW position (hot for both models). The other knobs and switches do not

matter.

2. If the unit is not plugged in, plug in and skip to step 6 or do a full control reset as in steps 3 to 5.

3. Hold the selector knob for 6 to 8 seconds and within 5 seconds complete steps 4 and 5.

4. Move the temperature knob to the far right position CW and push the selector knob

momentarily (<1 second)

5. The unit will indicate a full control reset by beeping 3 times, then move the temperature

knob to the far left CCW position (hot for both models)

6. Within 5 seconds complete the following to enter diagnostic mode.

7. Move the temperature knob to the far right CW position and push the selector knob momentarily

(<1 second)

8. Move the temperature selector to the far left CCW and push the selector knob momentarily (<1

second)

9. There will be a long beep signalling the entry into diagnostic / line test mode, if not start over with

an effort to perform the series faster or with more precision.

Need help?

Do you have a question about the Electrolux FFLE3911QW and is the answer not in the manual?

Summary

Diagnostic System

Diagnostic Mode

Defines the conditions and purpose of the diagnostic mode for testing.

Entering Diagnostic Mode

Step-by-step instructions to activate the diagnostic mode on the appliance.

Diagnostic Program Definition

Details the functions and sequence of each diagnostic program step.

Exiting Diagnostics Mode

Provides methods to safely exit the diagnostic mode.

User Interface Test

Verifies switch function and buzzer feedback on the user interface.

Hot Water Valve Test

Tests hot water solenoid and door lock activation.

Cold Water Valve Test

Tests cold water solenoid and clutch actuator.

Door Lid Unlock Test

Checks the function of the door lock mechanism.

Three Water Valves Test

Tests hot, cold, and softener water valves for proper operation.

Drain and Clutch Test

Verifies drain system and clutch operation.

Drain and Spin Test

Checks drain system and pressure sensor calibration.

Alarm History Test

Displays and allows clearing of stored error codes.

Washer Block Wiring Diagram

Dryer Block Wiring Diagram