Electrolux FLOW A3 User Manual

www.electrolux.com 7
9
7
8
GB
FI
SV
NO
DA
IT
PL
Fan speed control
Change the fan speed by gently touching fan icon
on the product. If the product is in AUTO mode, it
will switch to manual mode on touching the fan
icon. (ref. picture 7).
Auto mode and sleep mode
Change between AUTO and SLEEP mode by
gently touch icon labeled " ".
In AUTO mode the unit will adjust operation
according to latest air quality (PM2.5 level). In
SLEEP mode unit will operate at the low noise
level and all indicators except for SLEEP icon will
go off.
Power o
Power down the product by gently touching the
ON/OFF icon on the center of the product
(ref. picture 9)
AIR QUALITY INDICATOR
The appliance has an air quality sensor that
analyzes the air quality.
The air quality light will show the real-time air
quality through different colors of light. As shown
below:
10
LIGHT'S COLOR
Green
Yellow
Orange
Red
PM 2.5 (μg/m
3
) AIR QUALITY
0-12 Very Good
13-35 Good
36-55 Poor
>56 Bad
FILTER CHANGE INDICATOR
The filter change indicator will light up to
remind you to change the filter
(Ref. # EFFBRZ2).
• When filter change indicator flicker with red
light, please replace the filter and reset the filter
change indicator.
• When filter change indicator stop flicker and the
red light fix, please replace the filter immediately
and reset the filter change indicator.
11
12 Filter change indicator reset operation
Press the mode icon labeled " " for 3s and
filter change indicator will reset, then red
light will go off.
STORAGE
ERROR CODE
If you are not planning to use the appliance for
a long time, cover it with plastic or return it to its
carton.
Fan failure error code, when fan failure occurs, the
light of screen will all go o and the unit can’t be
operated then.
Air quality sensor failure error code, when sensor
failure occurs, the light of air quality indicator will
go off and the unit can’t be set on auto mode.
16
17
18
NOTE: The multi-layer lter can not be washed, it
can only be replaced.
CAUTION!
Do not touch the fan blade when removing the
multi-layer lter.
CARE AND CLEANING
Unplug the appliance before cleaning to prevent
shock or re hazards. Use a damp cloth or a
vacuum cleaner with soft brush to clean your air
purier.
The plastic part of the cabinet and top may be
cleaned with an oil-free cloth or washed with a
cloth dampened in a solution of warm water and
mild liquid dishwashing detergent. Be sure to
wring excess water from the cloth before wiping
around the controls. Excess water in or around
the controls may cause damage to the appliance.
Never use harsh cleaners, wax or polish when
cleaning the unit.
13
15
14

Electrolux FLOW A3 Specifications

General

Placement	Floor
Product color	Gray
Built-in display	No
Cord length	1.5 m
Noise level	50 dB
Air purify rate	180 m³/h
Number of speeds	3
Suitable for room area up to	40 m²
Anti-odor filter	Yes
AC input voltage	220 - 240 V

Weight and Dimensions

Width	240 mm
Height	380 mm
Weight	2800 g