Solutions to Common Problems
TemperaturesAre TooWarm
Problem Cause Correction
Freezer/Refrigerator • Doors are opened • Warm air enters the refrigerator wheneverthe door is opened. Open
temperature is too warm. too frequently or too the door less often.
long.
• Door is slightly • See Problem section, Opening/Closingof Doors/Drawers.
open.
Freezertemperature is • Freezercontrol is set • Setfreezer control to a colder setting. Allow 24 hours for
too warm. Refrigerator too warm. temperature to stabilize.
temperature is satisfactory.
Refrigerator temperature
is too warm. Freezer
_erature is satisfacto%
Temperaturein the Meat
Keeperis too warm (some
models).
• Refrigerator control • Set refrigerator control to a colder setting. Allow 24 hours for
is settoo warm. temperature to stabilize.
• Meat Keeper
temperature control
is settoo warm.
• Adjust Meat Keepertemperature control to a colder setting.
Water/Moisture/FrestInsideRefrigerator
Problem Cause
Moisture collects on inside • Weather is hot and
of refrigerator walls, humid.
• Door is slightly
open.
• Door is openedtoo
often or too long.
Opencontainers.
Water collects on bottom • Vegetablescontain
side of drawer cover, and give off
moisture.
Moisture collects in bottom • Washed vegetables
of drawer, and fruit drain while
in the drawer.
• Fruits and vegetables
are kept past their
prime
Moisture collects on • Weather is humid.
outside of refrigerator or
between doors. • Door is slightly
open, causingcold
air from inside
refrigerator to meet
warm air from
outside.
Correction
• Therateof frost buildupandinternalsweatingincreases.
See Problem section, Opening/Closingof Doors/Drawers.
• Open door less often to allow internal temperature to stabilize.
• Keep containers covered.
• Moisture on the bottom side of the cover is not unusual. Move
humidity control (some models) to lower setting.
• Dry items before putting them in the drawer.Water collecting in
bottom of drawer is normal.
• Routinely clean out old fruits and vegetables especially if they begin
to breakdown.
• This is normal in humid weather. When humidity is lower, the
moisture should disappear.
• See Problem section, Opening/Closingof Doors/Drawers.
PerfectTemDDrawer (some models)
Problem Cause
Display does not illuminate • Connectornot
or shows "CE". connectedor loose.
Display shows "LOG" when • Drawer in control
buttons are pressed, lock mode.
Correction
,, Remove panand insure connector is fully engaged. (SeeStorage
Featuressection)
• Press and hold control lock button for three secondsto take drawer
out of control lock mode. (SeeStorage Featuressection)
To Next Page
Loading...
