Electrolux KCC84453CK - Page 17

If you deactivate the hob while AUTO is
running, the function will be remembered
for the next cooking session.
Hood timer
Use the function to specify how long the hood
should operate.
It is not possible to set the hood timer while
the hood is deactivated.
1. Press
next to the hood control bar.
2. Press
or to set the time (00-99
minutes).
3. Press to start the timer.
The timer begins to count down.
• Once the timer finishes counting down, the
hood stops operating.
• It is possible to set the hood timer while
AUTO is on. If AUTO deactivates the hood
before the set time runs out, the timer will
be reset.
• If the timer deactivates the hood before
AUTO, the function will be switched off.
The indicators above 0 and AUTO will
disappear.
• In both cases AUTO will be activated next
time you switch on the hob.
Boost
The function activates the hood fan at its
maximum speed level.
1. Press
to activate the function.
A signal sounds and an indicator above the
symbol appears.
2. Press again to deactivate the function,
if needed.
The function can operate uninterrupted for a
maximum of 10 minutes. After that time the
fan speed setting automatically changes to 3.
You can activate the function again, if
needed.
Breeze
The function sets the hood fan to an extra low
speed. The fan starts running at a minimum
noise level immediately after the function is
activated. Use the function after cooking to
remove any lingering smells.
To activate the function when the hob is
off:
1. Press .
A signal sounds and an indicator above the
symbol appears. A timer set to 60 minutes
appears on the display next to the hood
control bar.
2. Adjust the timer using or , if
needed.
After the timer finishes counting down, the
hood deactivates automatically.
Auto Breeze
The function automatically sets the hood fan
to continue running after you finish cooking
and switch off the hob. The fan runs at a
minimum speed level for maximum 20
minutes. The function removes any lingering
smells after cooking.
When you use the hob for the first time, the
function is activated by default.
When the function operates, the indicator
above AUTO appears. The remaining runtime
is visible on the hood timer display. It is not
possible to adjust the set time. Once the
cycle is over, the fan switches off
automatically.
To deactivate the function while it is
running:
Press AUTO or 0 on the hood control bar.
The hood fan deactivates.
To disable the function completely:
1. Enter the menu: press and hold
for 3
seconds. Then, press and hold
.
2. Press
on the front timer until dF
appears on the display.
3. Press
or on the front timer until Off
(--) appears.
4. Press to exit.
ENGLISH 17