To Next PageTo Next PageWhat to do if glasses and dishes are not dried properly in Electrolux NUC1 Dishwasher?
If your glasses and dishes aren't drying properly, first check the dishwasher's rinse-aid levels. Refer to the instructions to ensure you're using the correct amount of rinse-aid. Make sure that the rinse-aid container is full and that the set amount of rinse-aid is correct.
How to fix smears or spots on glasses from Electrolux NUC1 Dishwasher?
If you notice smears or spots on your glasses, try reducing the amount of rinse-aid you're using.
Why is my Electrolux NUC1 Dishwasher not washing well?
Several factors can cause a dishwasher to not wash well. Start by checking if the suction filter is dirty and clean it thoroughly. Also, inspect the wash jets for any clogs caused by solid food remains. Ensure that you're using the correct amount of detergent and that the selected wash cycle isn't too short; if it is, repeat the cycle. Finally, verify that the dishes are stacked correctly in the racks to allow proper water circulation.
How to get rid of excessive foam in my Electrolux Dishwasher tank?
To eliminate excessive foam in the tank, begin by checking if the detergent dispenser is dispensing too much product. Also, make sure the tank hasn't been cleaned with unsuitable cleaners; if it has, drain the tank and rinse it thoroughly before starting new wash cycles. If a foaming detergent was used, drain the tank and refill it with water until the foam disappears.
What to do if there is condensation on glasses in Electrolux Dishwasher?
To reduce condensation on glasses, ensure that the rinse-aid container is full and that the set amount of rinse-aid is correct. Additionally, remove the rack of glasses immediately after the wash cycle has ended.
Why do the wash or rinse arms turn slowly in my Electrolux NUC1?
If the wash or rinse arms are turning slowly, start by removing and thoroughly cleaning the arms. Also, clean the wash pump suction filter.
General| Brand | Electrolux |
|---|---|
| Model | NUC1 |
| Category | Dishwasher |
| Language | English |
Contains model specifications and technical data.
Watermark labelled machines must be installed in accordance with AS/NZS 3500.1.
Earth and electrical connections must be in compliance with national regulations.
Descale the boiler, internal surfaces, and water piping.
Steps to begin operation.
Steps for running a wash cycle.
Identifies potential risks and safety measures.
