Electrolux Pure C9 - Tips for Best Results; Troubleshooting

www.electrolux.com
8
TIPS ON HOW TO GET THE BEST RESULTS
NOZZLE/ACCESSORY USE FOR: NOZZLE/ACCESSORY USE FOR:
T. Motorized nozzle* Carpet nozzle:
- Motorized nozzle gives the best
dust pick-up and deep cleaning of
carpets through the rotating brush
roller agitating the carpet.
- Do not leave the motorized nozzle
stationary with brush roller on.
U. FlowMotion nozzle*
V. FlowMotion LED
nozzle*
Universal nozzle:
- For all oor types, secures best dust pick up on
both carpets and hard oors.
- Change nozzle setting with the pedal. Icon will
show recommended oor type.
- Front light helps to detect dust and dirt in dark
spaces (under furniture etc). PureVision only
X. Mini Turbo nozzle* Upholstery nozzle:
- Brushes and vacuums at the same time (best
pick up of hair, bres etc).
- For textile furniture, car seats, mattresses etc.
- Brush roller is driven by the airow of the
vacuum cleaner.
- Not suitable for carpets with very deep pile and
long fringes as it can get stuck in the rotating
brush roll.
W. Turbo nozzle* Carpet nozzle:
- Brushes and vacuums at the same
time (best pick up of hair, bres etc).
- Brush roller is driven by the airow
of the vacuum cleaner.
- Not suitable for carpets with very
deep piles and long fringes, anti-slip
carpets like door mats or water
resistant carpets. Use universal
nozzle instead.
Z. FlexProPlus nozzle* Hardoor nozzle:
- For reach under/between furniture, corners and
other obstacles.
- Can easily turn 180 degrees for direct access to
narrow spaces.
Y. ParkettoPro nozzle* Hard oor nozzle:
- For gentle cleaning of hard oor
(parquet, wooden oor, tiles etc).
- Best dust pick up on hard oor with
crevice.
AB. BedPro nozzle* Bed nozzle:
- Removes dirt and dust mites from bedding and
mattresses.
AA. Long crevice nozzle* Extra long tool:
- For areas hard to reach (top of
shelves etc).
- For narrow spaces (behind radiators,
under car seats etc).
K. 3in1 accessory tool* 3 tools in 1:
1. Dusting tool for hard surfaces
(bookshelves, skirting boards etc).
2. Upholstery tool for textiles (curtains,
upholstery etc).
3. Crevice tool for narrow spaces
(behind radiators etc).
1 2 3
Models with manual power regulation
– follow graphics on cleaner for optimal performance.
TROUBLESHOOTING
PROBLEM SOLUTION
The vacuum cleaner does not start
• Check that the cable is connected to the mains.
• Check that the plug and cable are not damaged.
• Check for a blown fuse.
• Check if the battery indicator lamp in the remote control handle responds (certain models only).
The cleaner stops
The cleaner might be overheated: disconnect it from the mains; check if the nozzle, tube, hose or lters
are blocked. Let the cleaner cool down for 120 minutes before plugging it in again.
If the cleaner still does not work, contact an authorized Electrolux service centre.
Reduction of suction capacity versus
normal
• Check if the dust compartment is full or blocked.
• Check if the air channel and inlet or outlet connection is blocked and needs to be cleared.
• Check if the pre-motor lter is clogged and needs changing.
• Check if nozzle is blocked and needs to be cleared.
• Check if hose is blocked by squeezing it gently. However, be careful in case the obstruction has been
caused by glass or needles caught inside the hose.
Note: The warranty does not cover any damage to the hose caused by cleaning it.
Water has been sucked into the vacuum
cleaner
It will be necessary to replace the motor at an authorized Electrolux service centre.
Damage to the motor caused by the penetration of water is not covered by the warranty.
For any further problems, contact an authorized Electrolux service centre.