10
Maintenance Manual
Make sure that the motor is clean and that there is no lint. Clean with a vacuum cleaner if necessary. Make sure that
there is no lint around the air cooling inlets (C).
fig.W01026
Make sure that the areas around the motor inside the machine are clean and that there is no lint. Clean with a vac-
uum cleaner if necessary. Make sure that all lint has been removed and that all areas are clean before remounting.
fig.W01027
Remount the motor, the spring and the drum belt.
Connect the motor cable and remount the rear panel.
To Next Page
Loading...
Need help?
General
