46
Troubleshooting
E 06 - The drum motor has overheated (Motor 2)
Error description
The thermal protection switch inside the drum motor is connected to the PCB.
This error indicates that the thermal protection switch, or the harness between the
board and the switch, has opened.
A defective PCB can also cause this error.
The dryer stops operating.
Error analysis
E – 06
Check motor
harness and con-
nector. Replace
motor/harness/
connector.
YES
Go to step 3.
NO
Is there continuity
through the thermo fuse
for the drum (F8)?
Is the motor
cold?
NO
YES
Wait until the
motor is cold and
restart it.
The error occurs
immediately.
Replace the PCB
NO
YES
The error occurs
after a while’s
operation.
Defective motor
protection circuit
- replace the fan
motor or harness.
YES
2. Does the
motor run
slowly or is the
rotor locked?
Connect P1 and
P2. Does the
error reoccur
when the motor
is restarted?
NO
Put the dryer
back into
operation.
Replace
motor or clear
blockage.
YES
Is the motor seized?
3. Unplug
motor control
connector P1
and P2 from the
PCB.
Clean the motor.
NO
YES
1. Is the motor
clogged by lint
or dust?
Go to step 2.
To Next Page
Loading...
