5. If necessary clean the filter with the
brush under warm tap water and/or a
vacuum cleaner. Close the filter.
6. If necessary remove fluff from the filter
socket and gasket. You can use a
vacuum cleaner. Put the filter inside
the filter socket.
10.2 Emptying the water
container
Empty the condensed water container
after each drying cycle.
If the condensed water container is full,
the programme stops automatically. The
Reservoir symbol comes on the
display and you must empty the water
container.
To empty the water container:
1. Pull the water container out keeping it
in a horizontal position.
2.
Pull the plastic connection out and
drain the water into a basin or
equivalent receptacle.
3. Push the plastic connection back in
and place the water container back
into position.
4. To continue the programme press the
Start/Pause button.
10.3 Cleaning the condenser
If the symbol Condenser flashes on
the display, the condenser and its
compartment must be cleaned.
To clean the condenser and its
compartment:
1. Open the door.
2. Move the release button on the
bottom of the door to open the
condenser door.
3. Turn 2 blockages to unlock the
condenser cover.
www.electrolux.com34
To Next Page
Loading...
