Electrolux TE1120P - Troubleshooting

11. TROUBLESHOOTING
Problem
1)
Possible cause Remedy
The tumble dry-
er does not op-
erate.
The tumble dryer is not connec-
ted to mains supply.
Connect in at mains socket.
Check fuse in fuse box (domestic
installation).
The loading door is opened. Close the loading door.
The ON/OFF button was not
pushed.
Push the ON/OFF button.
The Start/Pause button
was not pushed.
Push the Start/Pause but-
ton.
The appliance is in the standby
mode.
Push the ON/OFF button.
The filter is missed or in wrong
position.
Insert the filter in the right posi-
tion.
The E59 error code on the display
- dryer overloaded.
Unload part of the laundry. Obey
the maximum load.
Unsatisfactory
drying result.
Incorrect programme selection. Do the selection of the applicable
programme.
2)
The filter is clogged.
Clean the filter.
3)
Too high volume of the load. Obey the maximum load volume.
The airflow grill is clogged. Clean the airflow grill in the bot-
tom of the appliance.
Dirt on the humidity sensor in the
drum.
Clean the front surface of the
drum.
Incorrect remaining laundry mois-
ture degree.
Adjust remaining laundry moisture
degree.
4)
The condenser is clogged.
Clean the condenser.
3)
The loading
door does not
closed
The filter not locked in the posi-
tion.
Put the filter in the correct posi-
tion.
The laundry is locked between
the door and the seal.
Put the load correctly in the drum.
Err (Error) on
the display.
You try to change the programme
or the option after the start of the
cycle.
Turn the tumble dryer off and on.
Make the new selection.
The option you try to activate is
not applicable with the selected
programme.
Turn the tumble dryer off and on.
Make the new selection.
www.electrolux.com36