Average annual energy consumption 282 kWh
Use Domestic
Permissible ambient temperature + 5°C to + 35°C
Consumption values
The consumption values have been established under standard conditions. They may deviate when
the machine is operated in domestic circumstances.
Programme
Energy consumption in kWh / average drying
time in min.
COTTON CUPBOARD DRY
2)
4.48 / 135 (8 kg load pre-drained at 1000 rpm)
4.3 (8 kg load pre-drained at 1200 rpm)
4.0 (8 kg load pre-drained at 1400 rpm)
3.5 (8 kg load pre-drained at 1800 rpm)
COTTON IRON DRY
2)
3.8 / 108 (8 kg load pre-drained at 1000 rpm)
SYNTHETICS CUPBOARD DRY
2)
1.3 / 45 (3 kg load pre-drained at 1200 rpm)
1) Different loading volume data may be needed in some countries as a result of different measuring
methods.
2) in accordance with EN 61121
Machine settings
Setting Implementation
Buzzer permanent on/off
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE (Schon) (1) and
SENSITIVE (Sensitiv) (2) buttons and hold down for ap-
prox. 5 seconds.
– diode above BUZZER (Signal) button (4) starts lighting
- buzzer permanently on.
– lighting diode comes off - buzzer permanently off.
3. The buzzer is by default always off. You can use the
BUZZER (Signal) button (4) to activate or deactivate
sound but the machine does not memorize your selec-
tion.
Water hardness
Water contains, a variable quantity
of limestone and mineral salts of
which quantities vary according to
geographical locations thus vary-
ing its conductivity values.
Relevant variations of the conduc-
tivity of the water compared to
those prefixed by the factory could
slightly influence the residual hu-
midity of the laundry at the end of
the cycle. Your dryer allows you to
regulate the sensitivity of the drying
sensor based on conductivity val-
ues of the water.
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE (Schon) (1) and
TIME (Zeitwahl) (5) buttons and hold down for approx. 5
seconds. The current setting is on the display:
–
low conductivity <300 μS/cm
–
medium conductivity 300-600 μS/cm
–
high conductivity >600 μS/cm
3. Press the START PAUSE (Start / Pause) button (6) se-
quentially until you set desired level.
4. To memorize setting press simultaneously the DELI-
CATE (Schon) (1) and TIME (Zeitwahl) (5) buttons or turn
knob to OFF (Aus) position
electrolux 17
To Next Page
Loading...
