Electrolux Unic Tango Ace - Page 33

33
Tango 0060 5-2021
Tango Turntable Service
Bearing Tension Final Adjustment
ACE / ST
Switch machine OFF and ON with the
Technician’s USB in place. Then press Info.
The Turntable speeds (Tt):
2 numbers = left and right rotation
170ms -190ms for newly installed seals
140ms -180ms machine already in use
Change the speed numbers
by adjusting the tension of
the Main Bearing
The Position Sensor
should stop between
the diamond cutouts
ACE / ST
UNO / SOLO
To display turntable speed:
Loosen 2.5 mm turntable lock screws
(Rotate shaft rst if needed)
TT is turntable speed