To Next Page

To Previous Page

ALARM CODES

SSD-P APdV, EB, HD 01/05 8.7 599 34 71-47

Are pressure switch hoses and the air

trap system free (you can disconnect

the hoses and blow in them to check

if the system is free) -see pic. 08,a,b-

YES

The analogic pressure switch is giving an error during the calibration phase

(At the beginning of each cycle the appliance drain to empty the tub

and create a 0 level to verify the calibration of the analogic pressure switch)

Checks to do:

E32

Clean/change the hoses and/or air trap

system and repeat completely the

diagnostic cycle to verify any further

possible fault

Select a washing cycle. After few

minutes did the machine fill with water

and the motor is turning?

Check the draining system (filter,

drain pump, drain hose). Is the

machine draining correctly?

Clean the draining system.

Machine is OK

Change the Analogic pressure switch

and run again the diagnostic cycle for

any further alarm code

YESYES

YES

Electrolux washing machine Service Manual

Other manuals for Electrolux washing machine