24
User manual
14Error codes
If power to the machine is accidently cut, the machine will restart automatically when power is restored. The machine
will resume the program it was running at the point the power was cut.
Faults/errors in the program or machine are indicate by a numerical error code on the panel display.
Some error codes are cleared automatically when the Start button is pressed to restart the machine and some when
the door is opened.
For the other error codes, a service technician must be called.
Error code Cause/Action
Err1 Door switch opened during a wash program.
Err2 Drain error. Water is not emptied within 15 minutes. Check drain pump strainer for clog.
Err3 Temperature sensor Error. Temperature sensor is damaged or the terminal is off.
Err4 Heating Error. Heating is damaged or the terminal is off.
Err5 Water level not reached within 8 minutes. Check water inlet screen for debris or clog.
Err6 Water level sensor error.
Err7 No motor rotation.
Err8 Water level signal above parameter set for safety, during program. Pump activates automatically.
Unb Unbalance load error. Open door and manually rebalance clothes， and press start within two minutes.
EuAr Communication error between display and power modules.
Door The door is not closed. Re-close the door.
To Next Page
Loading...
