22
Troubleshooting
If your television does not operate normally or does not turn on, please check the following
troubleshooting questions. Remember to also check the other connected electronic devices, such as DVDs
or Blu-ray players to pinpoint any problem. If the television still fails to operate normally, please contact
technical support (refer to Warranty page).
SYMPTOM POSSIBLE CAUSE REMEDY
Dead. No LED lit No power to the TV. Check all connections to the TV’s AC socket.
Dead. No LED lit red Set in standby mode.
Press either the Power button or the Standby button
on the remote control.
Blue screen
No signal.
Press SOURCE button to select the correct source
Incorrect source selected.
Noisy, snowy, ghosting
picture (TV)
Poor antenna signal.
If using an indoor antenna, try adjusting the antenna
postion. Check antenna connections
No sound
.FFO”etuM“dnuosnruT.”etuM“dnuoS
Volume set too low. Check volume settings.
External leads not connected
“if used”.
Check that all external leads are connected properly.
To Next Page
Loading...
