10
Chapter 1 Introducing the TV
How to setup the TV
Do not use caustic cleaners (porcelain, stainless steel, toilet, or oven cleaner
etc.) on the remote, as it may cause damage.
Use a supplied antenna cable to connect the VHF/UHF signal to the TV’s ANT.
terminal (refer to page14-18).
Connect the AC power cord to the back of the TV and connect the power cord to the
wall outlet.
Insert the 2 batteries supplied in remote control.
Connect other external AV devices (refer to page19-24).
Step1 Slide the back cover up to open the
battery compartment of the remote
control.
Step2 Insert two AAA size batteries.
Make sure to match the (+) and
( - ) ends of the batteries with
the (+) and ( - ) ends indicated
in the battery compartment.
Slide the cover back into place.
To Next Page
Loading...
