Element4 Sky - Operating the Fireplace

37
OPERATING the FIREPLACE
Element4 Gas Fireplaces EuropeanHome.com
BEFORE THE FIRST FIRE
1. Make certain that all construction materials have been removed from inside and around the replace and the replace has
been cleaned of any construction dust.
2. Conrm that the gas valve is properly connected and bled.
3. Check the gas supply for leaks and proper pressure.
4. Check that the venting is unobstructed and in proper working condition.
5. PROPERLY PLACE, CLAMP, AND SEAL THE GLASS PANELS.
6. Place the three AAA batteries into the remote control and conrm that it will communicate with the receiver by pressing
the ON/OFF. (See Figure 31) If necessary pair the remote and receiver.
7. Follow USING THE REMOTE CONTROL ELECTRONIC IGNITION SEQUENCE to setup and use remote.
THIS PART WAS INTENTIONALLY LEFT
BLANK