MANUAL command logic status
AUTOMATIC command logic status
Standby display brightness
Enabling ELENTEK name on panel
Maximum current setting in A/10
Alarm inhibition time at start-up in s/10
Pump start delay time in s/10
Tempo ritardo spegnimento pompa in s/10
Pump shutdown delay time in s/10
Minimum current alarm delay time in s/10
Tempo ritardo allarme massima corrente in s/10
Maximum current alarm delay time in s/10
Pump current calibration 1
Pump current calibration 2
Pump current calibration 3
Pump current calibration 4
Voltage board calibration 1
Voltage board calibration 2
To Next Page
Loading...