elero VarioTel 2 - Operation of the Transmitter with Combio JA Pulse; Deleting Positions;Deleting Transmitters

© elero GmbH 16 | EN © elero GmbH EN | 17
button, then release the STOP button. The new pulse duration is
stored. The new pulse duration corresponds to the total of all pulse
durations during programming of the pulse duration. The Combio JA
Pulse ends programming of the pulse duration after 30 pulses.
Deleting positions/deleting transmitters
Deleting the intermediate position in the receiver
1. Press both the STOP and DOWN buttons.
2. Hold down this button combination for approximately 3 seconds.
The status display lights briefl y.
Deleting the ventilation position in the receiver
1. Press both the STOP button and the UP button.
2. Hold down this button combination for approximately 3 seconds.
The status display lights briefl y.
Deleting the transmitter channel in the receiver
1. Press both the STOP button and the programming button P (on
the rear of the unit).
2. Keep this button combination pressed for approximately 6
seconds until the status display lights orange briefl y and then
lights red. In unidirectional radio operation, the status display
lights for 6 seconds: fi rst green briefl y twice and then red.
The channel in the transmitter is also deleted.
Deleting all the transmitters in the receiver
1. Press the STOP button and also the programming button P (on
the rear of the unit) + UP button + DOWN button.
2. Hold down this button combination for approximately 6 seconds.
The status display lights up orange-green briefl y twice, followed
by red (bidirectional).
The channel in the transmitter is also deleted.
In unidirectional radio operation, the status display lights for
6 seconds: fi rst green briefl y twice and then red.
2. Also press the STOP button. The blind stops. The status display
lights briefl y.
The ventilation position/tilting position is programmed.
Approaching intermediate position
Requirement
The transmitter/transmitter channel is programmed. The blind is at
its upper end position.
1. Press the DOWN button twice briefl y. The status display lights
briefl y.
2. The blind travels to the stored intermediate position. In the case
of Venetian blinds, after reaching the intermediate position,
the slats turn automatically. If no intermediate position is
programmed, the blind drives to the bottom end position (not
when Combio Pulse is used).
Approaching ventilation/tilting position
Requirement
The transmitter/transmitter channel is programmed. The blind is at
its lower end position.
1. Press the UP button twice briefl y. The status display lights briefl y.
2. The blind travels to the stored ventilation/tilting position. If no
ventilation/tilting position has been programmed, the blind
moves to the top end position (not when Combio Pulse is used).
Operation of the transmitter with Combio JA Pulse
A Combio-868/-915 JA Pulse can be used for blind drives for precise
adjustment of the slats. The system is operated for the pulse time set
in the Combio Pulse when the UP or DOWN button is pressed.
The pulse duration can be modifi ed by the user. To do this, press
and hold the STOP and UP button on a taught-in transmitter for
6 seconds. The drive begins to move in short pulses. As soon
as the curtain has covered the desired distance, release the UP
E
x
p
lanation of functions
E
x
p
lanation of functions