English
Lubricants
Engine (0,75 l) SUNOCO SUPER DENALUBE
SAE 20 W 50 API SF / CC
Bearings NOVATIO PTFE OIL
Wheel axles SUNOCO GREASE MULTI-PURPOSE LR - EP2
11.3 Routine Checks before the Start of Each Work Session
11.3.1 Visual Check
Check that no parts are deformed, no welded seams are cracked, and that no parts
exhibit excess play. First conduct the necessary repairs if any problems are found.
Check whether the machine is running at the manufacturer’s engine speed (3,200 rpm)
(a tachometer can be obtained from your ELIET Dealer). Never try to change the stan-
dard settings of the engine.
11.3.2 Checking the Oil Level of the Engine
Park the machine on a level surface making sure the motor bed plate is as close to level
as possible.
Open the manual at Chapter 6 to locate the oil drain plug and the crankcase filler point.
Take a clean cloth and clean the fill area.
Unscrew the yellow oil filler plug, located to the right of the engine.
This will enable you to check for correct oil level. Normally, the oil level should reach the
edge of the filler point.
If the oil does not reach the edge there is not enough oil.
If the oil level is too low, it is simply a matter of replenishing through
this filler point. Fill until the desired level is reached.
Use a funnel with a built-in sieve.
Only use the recommended oil.
Immediately clean off any spilled fuel.
Caution:
Make sure that no dirt enters the casing via the fill stud.
11.3.3 Cleaning the Air Filter
The air cleaner is located behind the black safety guard underneath the choke lever
on the engine.
31
To Next Page
Loading...
