12. Off-Season Storage
Clean the machine (see Chapter 9.8).
When storing the machine for long periods, it is recommended to perform the follo-
wing steps.
Conduct a major overhaul (see Chapter 11.4).
Check all nuts and bolts for correct tightness. Checking most bolts for correct tight-
ness simply involves the use of two sets of open-ended spanners (10, 13 and17).
Drain the fuel tank. Simply run the engine until the fuel tank is out of fuel and the
engine stops. Alternatively, use a siphoning kit to dispense the remaining petrol in the
jerry can (see the safety instructions included in Chapter 9.2).
Remove the sparking plug (see Chapter 11.4.2). Spray some penetrating oil containing
molybdenum disulphide into the cylinder through the spark plug hole. Then pull on the
starter cord for the piston to reach the top of its stroke. Refit the spark plug.
Places where the paint coating is damaged are repainted or covered with grease in
order to prevent rust. ELIET original paints are available from your ELIET Dealer.
Store the machine in a dry place that is protected against rain, and if necessary, cover
it with a tarpaulin.
Always allow the machine to cool down before storage.
If the machine is to be stored outside, it must be well protected with a tarpaulin.
Ensure that water does not directly fall onto the machine. ELIET strongly recommend
that the machine is stored at a location that is well protected from the weather, etc.
Never keep the machine in a place where it can come into contact with a naked flame
source.
38
English
To Next Page
Loading...
